Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Mission Hill?
Garage door work in Mission Hill typically runs $150 to $600 for a repair, and $700 to $2,200 for a new door installed. That spread covers everything from a worn roller swap to a full replacement, so the number that applies to your door depends on which parts failed and how much of the system they took with them. We give written estimates up front, and the written estimate is the price you pay.
Mission Hill is an old, tight neighborhood, and that shapes what we see on the job. Most of the housing stock here is wood-frame triple-deckers and early twentieth century brick rowhouses, and many of those properties have detached or semi-attached garages squeezed into a back lot or a narrow alley off the street. There isn’t much clearance. Our technicians have up to 14 years of experience and work on eight major brands, including LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor, which means we usually know what we’re looking at before we pull into the alley.
If your door is stuck open, hanging off a track, or making a noise that wasn’t there yesterday, call (844) 944-1933. Estimates are free, and we can often get someone out the same day.
Key Takeaways
- Typical garage door repair in Mission Hill runs $150 to $600.
- Spring repair is $180 to $340 for one spring; matched pairs usually cost about twice that.
- A full new door installed runs $700 to $2,200, depending on size, material, and what your opening can take.
- Free estimates, and the written estimate sets the final price.
- We service eight major door and opener brands, so parts delays are rare.
Garage Door Cost Breakdown (2026)
Here’s what the common jobs cost in Mission Hill this year. These are typical estimated ranges, not quotes. The written estimate sets the final price.
| Job | Typical Estimated Range |
|---|---|
| Garage door repair (general) | $150 – $600 |
| Spring repair (one spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
A few notes on reading the table. Spring pricing is for one spring. Most residential doors carry a matched pair, and those springs are replaced together because they’re the same age and the same amount of wear – a pair costs about twice the single-spring range. Same logic applies to cables, which fail in pairs more often than not.
What pushes a job toward the top of a range? A snapped torsion spring on a heavy wood door costs more than the same job on a light steel door, because the spring itself is sized larger. A panel replacement on a discontinued Clopay or Wayne Dalton profile can land higher if we have to source an exact match. An opener repair on a LiftMaster with a fried logic board runs more than a stripped gear on a chain drive. What pulls a job toward the bottom? A single bad roller, a track knocked out of plumb by a bumped bumper, a remote that won’t pair. Those are quick, and they’re priced like it.
What Affects Garage Door Pricing in Mission Hill
- The kind of spring system. Torsion springs, mounted on the shaft above the door, and extension springs, mounted along the horizontal tracks, aren’t priced identically. Torsion setups take longer and require more careful winding to balance. If you don’t know which you have, we can tell you over the phone once you describe where the springs sit.
- The age and construction of the door. A lot of Mission Hill garages were built decades ago and still have the original wood door, or a steel door that’s been repainted more than once. Heavier, older doors need heavier springs, and sometimes the hardware has been patched by previous owners in ways that add labor to a simple repair. We don’t upcharge for guessing at prior work – we upcharge only when the job genuinely takes longer.
- Alley access and clearance. This is the local factor that surprises people. Many Mission Hill garages sit behind the house, reached through a narrow alley or a shared drive. Ceiling height in older garages is often lower than a modern standard, which limits which openers we can fit and how the rails are mounted. Tight quarters add a little time to an installation, and time is part of the price.
- Brand and parts availability. We work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor equipment regularly, and we supply parts directly. That matters for cost: a job that would be held up by a third-party parts order isn’t held up here, and we’re not marking up a middleman.
- Seasonal wear. Boston winters are hard on garage doors. The freeze-thaw cycle stresses cables and rollers, and the salt and grit tracked onto the tracks by tires accelerates wear. Doors that were fine in October often start complaining in January. Winter repairs aren’t inherently more expensive, but they do come in clusters – so if your door is showing early warning signs in the fall, a small repair now is cheaper than a bigger one later.
- Opener type. Belt drive, chain drive, screw drive, and jackshaft openers don’t all cost the same to replace. A belt drive unit is quieter and typically costs more than a chain drive. A jackshaft opener, which mounts on the wall beside the door rather than the ceiling, is the right fit for some low-clearance Mission Hill garages and prices on the higher end of the opener installation range.
Repair or Replace? A Cost Question Worth Asking Early
It’s cheaper to repair a garage door than to replace one, as long as the door structure itself is sound. The tipping point in Mission Hill pricing terms is usually around $600 to $700 of accumulated repair cost on a door that’s already showing panel damage, rust-through, or repeated spring failures. At that point, putting money into the old door is spending toward the next problem.
Here’s the practical test. If the door panels are intact and the tracks are straight, repair almost always wins. Spring repair, cable repair, opener repair, and roller replacement are all routine jobs that add years to the door. If the panels are dented, the bottom section is rotted, or the door has been hit by a car, panel replacement at $250 to $500 can be the smarter middle option – you keep the existing opener and hardware and swap only what’s damaged. Full replacement at $700 to $2,200 makes sense when multiple sections are compromised or the door is beyond matching.
We’ll tell you honestly which side of that line your door falls on. If we can fix it, we’ll say so. If you can see that for yourself after a look at the numbers, you already have your answer – call us for a free estimate either way.
How to Save on Garage Door Repairs in Mission Hill
There’s no magic discount on garage door work, but there are real ways to keep the bill on the lower end of the ranges above.
- Catch it early. A cable that’s starting to fray costs less to replace than a cable that snapped and torqued the door out of the tracks. If you hear a pop, see a gap in the cable windings, or notice the door getting harder to lift, call before it fails completely.
- Replace springs in pairs. We know it sounds like more money up front. It usually isn’t over time – replacing one spring on a matched pair and leaving the other is how you end up paying for two separate service visits within a year.
- Lubricate the moving parts. Rollers, hinges, and tracks benefit from a proper garage door lubricant a couple of times a year. It won’t fix a worn roller, but it slows the wear and keeps the door running quietly. Ask us which lubricant we recommend for your hardware.
- Keep the tracks clean. Boston grit and road salt work their way into the tracks and chew up rollers. A wipe-down of the vertical and horizontal tracks now and then is a cheap habit that prevents a roller replacement visit.
- Get a written estimate before work starts. Free estimates mean you know the number before anyone touches the door. Call (844) 944-1933 and we’ll price it out.
Why Brand Knowledge Keeps the Price Down
One reason a garage door bill can climb is trial-and-error diagnosis. A general handyman who doesn’t know the difference between a LiftMaster logic board and a Chamberlain wall control can spend an hour figuring out what’s wrong and then charge you for it. That’s how a simple opener repair turns into a bill at the top of the range.
Garage doors are the only thing we do. We’re factory-familiar with eight major brands, and our technicians diagnose from the model and symptom rather than by swapping parts until something works. That means fewer repeat visits, fewer incorrect parts ordered, and less of your money spent on someone else’s learning curve. We also supply parts directly, so if you’d rather replace a roller or a hinge yourself, you can get the right one from us without hunting down a specialty supplier.
If you’re looking at a bigger picture problem and want to understand the full scope of what a specialist handles, our Roslindale Garage Door Repair page lays out the repair, opener, spring, installation, and parts services we cover.
What About Spring Repair in Mission Hill?
Spring repair runs $180 to $340 for one spring in Mission Hill, and a matched pair typically costs about twice that. Spring repair is the job we get called for most, and it’s the one we’d most want you to leave alone.
Torsion and extension springs are under extreme tension at all times, even when the door is closed. A spring that’s about to fail can snap without warning, and the hardware attached to it moves with enough force to cause serious injury. General handymen often decline the job for exactly this reason. We do it as routine work, with the right winding bars and the right precautions.
If your spring has snapped, don’t try to open the door by hand. The door is now unbalanced, and lifting it can bring it down hard. Call us at (844) 944-1933 and we’ll get someone out to assess it.
Opener Repair or Replacement: Which Costs Less?
Opener repair costs $120 to $320, and opener installation costs $250 to $550. Repair is almost always cheaper – unless the opener is old enough that the failed part is no longer made, or the motor itself is shot. In that case, the replacement sits within the same range as a substantial repair, and you’d have a new unit to show for it.
A few symptoms point toward repair: the opener runs but the door doesn’t move (usually a gear, a belt, or a stripped trolley). The opener hums and stalls (a capacitor or a bound door). The wall control works but the remotes don’t (a receiver or reprogramming issue). A few point toward replacement: the motor is grinding, the unit is very old and parts are discontinued, or you’re upgrading to a quieter belt drive or a jackshaft because of low ceiling clearance in your garage.
We work on all the major brands – LiftMaster, Chamberlain, Genie, Craftsman, and the rest – so the diagnosis is usually quick. If you’re not sure whether your opener is worth fixing, describe the symptom on the phone and we’ll give you a straight answer.
FAQs – Garage Door Cost in Mission Hill
How much does garage door repair cost in Mission Hill?
Garage door repair in Mission Hill typically costs $150 to $600, depending on which parts failed and how much labor the job requires. Spring, cable, roller, and track work all sit within that range. Call (844) 944-1933 for a free estimate – the written estimate sets the final price.
How much does a new garage door cost in Mission Hill?
A new garage door installed in Mission Hill typically runs $700 to $2,200. The low end covers a standard single-car steel door; the high end reflects a larger opening, a heavier or insulated door, or the extra labor that low-clearance Mission Hill garages can require. Call (844) 944-1933 for a free estimate.
Is it cheaper to repair or replace a garage door?
Repair is cheaper than replacement when the door structure is sound – a repair runs $150 to $600 versus $700 to $2,200 for a new door. Replacement makes more sense when multiple panels are damaged, the door has been hit, or accumulated repair cost approaches the price of a new door. Call (844) 944-1933 and we’ll tell you honestly which side your door falls on.
Why does my garage door cost more in winter?
It usually isn’t the repair that costs more in winter – it’s the number of failures. Boston’s freeze-thaw cycles stress cables and rollers, and the grit and salt tracked into the tracks shortens their life. A winter repair on a spring or cable normally falls within the same $130 to $340 range as any other time. If your door is showing warning signs in the fall, a small repair before winter usually beats a bigger one after. Call (844) 944-1933 to get ahead of it.
Can you come today?
Often, yes. Spring and cable failures are the most common urgent calls we get in Mission Hill, and we prioritize doors that are stuck open, hanging off track, or unsafe to operate. Call (844) 944-1933 early in the day and we’ll do our best to get someone to you the same day – and if we can’t, we’ll tell you straight.
What to Do Next
If your door is failing, the cost of waiting is usually higher than the cost of the repair. A cable that’s fraying becomes a door that’s out of track. A roller that’s grinding becomes a track that’s chewed up. And a spring that’s on its last wind becomes a door you can’t open at all.
Give us a call at (844) 944-1933 for a free estimate. We’ll tell you what’s wrong, what it costs, and whether repair or replacement is the smarter money – and you’ll have the numbers in writing before anyone starts work. Garage doors are all we do, and that’s exactly the point.
Pricing reflects the Mission Hill market as of 2026. Roslindale Garage Door Repair offers free estimates – call (844) 944-1933.
Written by the team at Roslindale Garage Door Repair.
What Our Customers Say
"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- Colleen Norris"Keypad stopped working, which I assumed meant a whole new system. It was the batteries and a reprogram. He charged me the minimum service call and told me how to do it myself next time."
- Travis Rhodes"Logic board on a 15 year old opener. He was upfront that a new opener would cost less than the board plus labor, and he wasn't wrong. No pressure either way."
- Dustin Gallagher